Crystal Powder Polymer Cationic Polyacrylamide Flocculant For Oil Field Chemicals

Basic Specification:

Summery of Polyacrylamide In Different Formula

Advantage of Our Polyacrylamide(PAM)

• Economical to use - lower dosage levels.

• Easily soluble in water; dissolves rapidly.

• Non corrosive of suggested dosage, economical and effective at low levels.

• Can eliminate the use of alum & further ferric salts when used as primary coagulants.

• Reduction in sludge of dewatering process system.

Introduction Of Cationic PAM

• Mainly used as flocculant: for suspended particles, coarser, higher concentration, positively charged particles, water PH value is neutral or alkaline sewage, because the anionic polyacrylamide molecular chain contains a small amount of polar groups to adsorb water suspension The solid particles cause bridging between the particles to form large flocs. Therefore, it accelerates the sedimentation of the particles in the suspension, and has a very obvious effect of accelerating the clarification filtration of the solution. This product is widely used in chemical industry wastewater, waste liquid treatment, municipal sewage treatment. Water treatment in tap water industry, high turbidity water purification, sinking, coal washing, mineral processing, metallurgy, steel industry, zinc, aluminum processing industry, electronics industry;
• Used in petroleum industry, oil recovery, drilling mud, waste mud treatment, prevention of waterlogging, friction reduction, enhanced oil recovery, and tertiary oil recovery.
• It is used for textile sizing agent, stable slurry performance, less slurry falling, low fabric breakage rate and smooth surface.
• Used in the paper industry, the first is to increase the retention rate of fillers and pigments. To reduce the loss of raw materials and environmental pollution; the second is to improve the strength of the paper (including dry strength and wet strength), in addition, the use of PAM can also improve paper tear resistance and porosity to improve visual and printing performance, also used In food and tea wrappers;
• In other industries, the food industry is used for the clarification of cane juice and the extraction of syrup phosphorus floatation in the production of cane sugar and beet sugar. Enzyme preparation fermentation liquid flocculation clarification industry, also used for recovery of feed protein, stable quality, good performance, recovered protein powder has no adverse effect on chicken survival rate and weight gain, egg production, synthetic resin coating, civil grouting material blocking water, building materials industry, improve the quality of cement, construction adhesives, caulking repair and blocking agent, soil improvement, electroplating industry, printing and dyeing industries;

Jar Test

Put sample of effluent in a beaker and add it as designated, agitate for 1 minute at 100-120 rpm and then slowly agitate at 60rpm. Determine the floc properly at this time and note the sedimentation and clarity of top solution.

Precautions

1. The operator should wear protective equipment. After skin contact, wash it with water;

2, the use of the site, if there is a small amount of leakage, can be washed with a large amount of water; such as a large number of leaks, first sweep and then rinse with a large amount of water, emergency can be sprinkled with a large amount of yellow sand to prevent slipping injuries;

3. This series of products should be sealed thanks to the cool and dry place to prevent moisture;

4. The storage period is one year.

Instruction of Use

1. It should be formulated into 0.1-0.3% aqueous solution when using, and it is suitable to use neutral water without salty impurities;

2. Spread the dry powder of the product into the stirred water evenly to ensure that it is well dispersed and swollen in the water (do not add water after adding the powder), so as not to form a "fish eye" or block the dosing pipe, and the operation failure occurs. . The stirring speed is controlled at 100-300 rpm;

3. The solution of this series of products should be ready to use, and should not be placed for more than one day after preparation. When preparing, transferring and storing the product, the equipment in contact with the solution is made of stainless steel, plastic, glass or fiberglass;

4. When this series of products is combined with inorganic coagulant, inorganic coagulant should be added first, when there is obvious scented flower (usually about 30-60 seconds), then add this series of products, can not reverse the order Can not be joined at the same time;

5. The dissolved flocculant is applied by a low-shear conveying such as a screw pump or a diaphragm pump.